GMD SD40-2 ← →
| 1973-03 - 1974-01
| 1b
| ONT 1730-1737
| 8
|
| 2023-01-09Revision history:
2016-12-14
- Removed plate between bell bracket
2019-08-12
- Relocated front hood seam resulting in revised hood proportions
- Front section of hood lengthened and blower duct widened by 1"
- Revised hood section under inertial air intake
- Gap from seam to middle hood doors shortened by 0.75"
- Middle hood doors shortened by 0.25"
- Increased height of walkway blower duct and bottom of hood doors
- Corrected seam at bottom corners of long hood
- Revised radiator intake grills and roof fan hatch
- Revised exhaust stack
- Corrected minor line glitch on latches first engine room door
2020-12-19
- Revised side handrail stanchions
- Increased handrail thickness
- Corrected rear corner handrail length (right side)
- Revised radiator fan dimensions and spacing
- Fuel tank vent pipe (increased diameter, revised fittings)
- Air pipe vent valve (left front / right rear under walkway)
- Sand lines (larger pipe diameter, revised hoses)
- Added missing line segment in traction motor cables above fuel filler (left side)
2021-01-09
- Fuel tank height and gap from underframe
2022-03-29
- Coupler cut lever and pilot details
- Corner handrail end plate / stairwell attachment points
2023-01-09
- Long hood end seams
|