Top header photo
 Trainiax logo
HomeNewContactLinks

Undecorated Drawings - ITC

Selected scales:


1:18 Drawings

Model Built Phase Numbers Notes Last modified
EMD GP38-2
  
1977-05 2a1 ITC 2001-2004
2023-01-09Revision history:

2014-02-16
- Truck shape and casting logos

2014-10-23
- Radiator fans (bottom rim edge and upper rim clips)

2015-03-29
- Inertial air intakes (revised upper/lower ridge detail)
- Rear steps (removed top step corner extension)

2017-09-27
- Revised position of lift ring and flag holder at rear of long hood
- Corrected minor line glitch on latches on first engine room door

2019-01-22
- Relocated front hood seam resulting in revised hood proportions
- Front section of hood lengthened and blower duct widened by 1"
- Revised hood section under inertial air intake
- Gap from seam to middle hood doors shortened by 0.75"
- Middle hood doors shortened by 0.25"
- Increased height of walkway blower duct and bottom of hood doors
- Corrected seam at bottom corners of long hood
- Revised paper air filter housing and dynamic brake taper
- Revised roof fan hatch

2019-01-24
- Front left traction motor cables moved 2.25" rearward
- Front right traction motor cables and air piping moved 0.75" to 1" rearward

2020-12-08
- Revised side handrail stanchions
- Increased handrail thickness
- Revised radiator fan dimensions and spacing
- Fuel tank vent pipe (increased diameter, revised fittings)
- Air pipe vent valve (right rear under walkway)

2021-01-09
- Air pipe vent valve (left front under walkway)
- Fuel tank height and gap from underframe

2022-02-08
- Coupler cut lever and pilot details
- Corner handrail end plate / stairwell attachment points
- Revised ribs on blower duct

2022-03-03
- Horn manifold and back cap dimensions

2023-01-09
- Long hood end seams

1:36 Drawings

Model Built Phase Numbers Notes
EMD SD39
  
1969-05 -
1969-06
ITC 2301-2306

See also: